Description
Autel MaxiFlash VCI Vehicle Communication Interface
Highlights:
1. Supports CAN FD, 4 CAN Channels, and DolP
2. Supports D-PDU, IS 022900-1 & Iso 22900-2 Protocols and is RP1210 Compliant
3. Use with Windows PC for OE Programming, J2534-1 & J2534-2 Compliant
4. Program BMW & Mercedes from MaxiSYS MS909, MS919 and MSUltra Tablets
5. Compatible with AUTEL Ultra Lite/ Ultra Lite S, AUTEL MS909, AUTEL MS909 EV, AUTEL Elite II Pro, AUTEL MS909CV
Notes:
1. Do Not Disconnect The Programming Device While The Vehicle LED Status Light is On! If the flash programming procedure is interrupted while the vehicle’s ECU is blank or only partially programmed, the module may be unrecoverable.
2. The CAN FD/DoIP Protocols Are Not Universal to All The Vehicles. The CAN FD protocol is mostly applicable for GM produced in and after 2019, and the DolP protocol mainly supports for Volvo after 2018, for L-and Rover/for Jaguar after 2017, for BMW F chassis and G chassis
The MaxiFlash VCI Kit, compatible with the MaxiSYS MS909 advanced diagnostic tablet, includes a bluetooth-enabled vehicle communication interface (VC), a J2534- compliant pass-thru programming device. The MaxiFlash VCI can be use with Windows computer with applicable OE subscription for vehicle module programming and when connected to the MaxiSYS tablets for compatible BMW and Mercedes vehicle module programming.
Communication Capability
The MaxiFlash VCI supports Bluetooth (BT), Wi-Fi, and USB communications. It can transmit vehicle data to the tablet with or without a cable connection. In open areas, the working range of the transmitter through Bluetooth communication is up to 328 feet (about 100 m). The working range of 5G Wi-Fi is up to 164 feet (50 m). If the signal is lost due to being taken out of range, communication will be restored once the tablet is within range.
The MaxiFlash VCI is a D-PDU, SAE J2534 & RP1210 compliant PassThru programming interface. Using the updated OEM software, it is capable of replacing the existing software/firmware in the Electronic Control Units (ECU), programming new ECUs, and fixing software-controlled drivability issues.
Power Sources
The VCI can receive power from the following sources: Vehicle power, AC/DC power supply.
Vehicle Power
The VCI operates on 12/24 Volt vehicle power, which receives power via the vehicle data connection port. The device powers on whenever it is connected to an OBDII/EOBD compliant Data Link Connector (DLC). For non-OBDII/EOBD compliant vehicles, the device can be powered from an auxiliary power outlet on the test vehicle using the auxiliary power cable.
AC/DC Power Supply
The VCI can be powered from a wall socket using the AC/DC power adapter.
1 – DC Power Supply Input Port
2 – Vehicle Data Connector
3 – Ethemet Port
4 – Vehicle LED
5 – Connection LED
6 – Power LED
7 – USB Port
Specification:
Communications: BTV2.1 + EDR; USB 2.0; Wi-Fi 5G; Ethernet
Wireless Frequency: 5 GHz
Input Voltage Range: 12 VDC to 24 VDC
Supply Current: 170mA@12VDC; 100mA@24VDC
Operating Temp: 0°Cto 50 °C (32 to 122 °F)
Storage Temp: -20 °Cto 60°C(-4 to 140 °F)
Package List:
1pc x AUTEL MaxiFlash VCI
